Schönox ES 484551 silicone sealant 300ml silver gray

Schönox ES silicone sealant

Anti-fungal. Permanently elastic. For sealing and sealing of connection and expansion joints. For interior and exterior use.

Product characteristics

• resistant to greater temperature differences
• elastic
• fungicidal
• Without pretreatment on glass, enamel, glazed ceramic tiles, clinkers, etc.
• resistant to aging, water, sea water, carbonic acid, ozone, UV rays, common cleaning and polishing agents

Scope of application

• Sealing and sealing of connection and movement joints, such as between tiles and bathtub, sink, shower tray, pipe penetrations, toilet fixtures, sink, etc.
• inside and outside
• sealing of full glass constructions (glass construction)

Surface requirements

• The joints must be dry and free of dirt and separating agents.
• For joint widths of 5 to 10 mm, the joint cross-section must be square.
• Joint widths of 10 to 20 mm require a joint depth of 10 mm.
• For joint widths above 20 mm, the joint depth may be half the joint width.
• Fill deeper joints with foam or suitable material.
• Avoid three-point bonding.
• Pre-treat stainless steel, aluminum, plastics and alkaline substrates such as plaster, masonry, concrete, etc. with a suitable primer.

Technical Data

• One-component silicone sealant base
• Skin formation after approx. 15 minutes
• Application temperature +5 °C to +40 °C
• Temperature resistance when cured -40 °C to +180 °C

Consumption

Consumption depends on the joint size. A tube of Schönox ES is sufficient depending on the joint width/depth - for the following joint lengths:

• joint size (width x depth) 5 x 5 mm -> 1 tube is sufficient for approx. 12 m
• joint size (width x depth) 6 x 6 mm -> 1 cartridge is sufficient for approx. 8.5 m
• joint size (width x depth) 7 x 7 mm -> 1 tube is sufficient for approx. 6.5 m
• joint size (width x depth) 8 x 8 mm -> 1 tube is sufficient for approx. 4.5 m
• joint size (width x depth) 10 x 10 mm -> 1 tube is sufficient for approx. 3.0 m
• joint size (width x depth) 12 x 10 mm -> 1 tube is sufficient for approx. 2.5 m
• joint size (width x depth) 15 x 10 mm -> 1 tube is sufficient for approx. 2.0 m
• joint size (width x depth) 20 x 12 mm -> 1 tube is sufficient for approx. 1.3 m

Instructions for use

• Cover edges with self-adhesive tape.
• Fill joints evenly with Schönox ES.
• Immediately smooth the surface with a damp spatula, wet jointing board, jointing iron or finger. Use washing-up liquid before grouting.
• Remove tape immediately.

Storage

• Store in a cool, dry and frost-free place.
• Can be stored for 18 months.
• Use opened containers in the short term.

Advice

• Vulcanized mass can only be removed mechanically.
• For technical reasons color differences may occur between the tubes. However, these do not affect the quality of the silicone sealant. We are not liable for these or other color deviations.
• Due to the acidic hardener system, the possibility exists that some metals (lead, iron, zinc) may rust. Cq. provide adequate protection.
• The fungicidal equipment of Schönox ES prevents mold on the sealant surface. High humidity, heat, light and irregular cleaning promote mold.
• A joint compound is a maintenance joint. Please note the ZDB trademark sheet "Bewegungsfugen in Bekleidungen aus Fliesen und Platten" (September 1995).