Magnum Cable 102605 X-treme Control set floor heating 152.9 meters - 2600 watts

Magnum Cable underfloor heating

The Magnum Cable is specially designed for installation in cement screeds. The cable spacing determines the power per^m2. This gives you the freedom to install more power (faster reaction, higher temperatures) or less power (for constant or low temperatures). Because the cable is deformable, installation is easy. It can be attached by Alu-tape to Magnum Isorol and dovetailed sheets or with tiewraps to concrete mesh. Convenient spacer strips are also available for direct installation on the floor.

The advanced thermostat takes into account the required warm-up time, so your floor is always the right temperature at the desired time. The absence of radiators on the wall offers optimal freedom in interior design.

Sample cable spacing calculations:

To calculate the correct cable spacing, divide the number of^{m2 of} free floor space by the total capacity of the set. Multiply the result by 17 (17 = watts per meter of cable). The first two decimal places indicate the cable spacing in centimeters.

Some examples of supplemental heating:

500 watt cable on 3^m2: (166 ^W/m2) (3^m2: 500 watts) x 17 ^W/m1=0.102. Fit cable 10 cm apart. 1000 watt cable on 7^m2: (142 ^W/m2) (7^m2: 1000 watts) x 17 ^W/m1=0.119. Mount cable 11 to 12 cm apart.

Magnum Cable is supplied as a complete set:

• Heating cable
• Magnum X-treme Control clock thermostat
• Floor sensor
• Flexible pipe for floor sensor
• Mounting tape
• Installation instructions

Warranty:

Magnum Cable has a lifetime warranty on the electrical operation of the heating cable and 2 years on the thermostat and floor sensor.

Technical data:

• EMC-free 2-conductor cable
• Power cable 2.5 meters three-core
• Unique blind connection between heating and connection cable
• Complete enclosure by aluminum ground sheath
• Chrome/Nickel resistance wire
• XLPE insulation
• PVC protective jacket
• 17 Watt per meter output, 230 Volt
• Cable diameter: 7 mm
• Produced and checked in accordance with IEC 800 standards
• NEMKO approved and CE standardized within Europe

The cables are available in total powers from 300 to 3300 watts, sufficient for areas between 2 and 30^m2. Because the cable is interconnected at the end, there is only a power cable on one side, which is invisibly attached using the unique connection. This eliminates the need for a return to the thermostat.

Mounting: