Magnum Mat Large 203005 X-treme Control set underfloor heating 1875W 15,00 M²

Magnum Mat underfloor heating

The MAGNUM Mat is a unique underfloor heating mat. The system is designed to be installed over an existing tile floor or on a finished floor to provide underfloor heating. The mat is approximately 4 mm thin and can be embedded in a layer of adhesive without the need for demolition or milling. The mat is placed directly beneath the surface, which increases the floor's heating speed, making the system suitable for spaces with non-permanent occupancy, such as bathrooms, hobby rooms, and recreational areas. The advanced thermostat takes into account the required warm-up time, ensuring that your floor always reaches the desired temperature at the right time.

The MAGNUM Mat is available in 22 different sizes ranging from 0.75 to 25 square meters. Because the heating cable is interconnected at one end of the mat, only one side requires a power supply cable, which is invisibly attached using a unique connection. As a result, there is no need to run a return cable to the thermostat.

The MAGNUM Mat is supplied as a complete set, including:

• Heating mat
• MAGNUM X-treme Control thermostat with floor sensor
• Flexible tube for the floor sensor
• Installation instructions & Check/Control card

Certification:

The MAGNUM Mat is VDE certified. VDE is one of the largest technical and scientific certification bodies in Europe.

Warranty:

MAGNUM Mat has a lifetime guarantee on the electrical functioning of the heating mat and a 2-year guarantee on the thermostat and floor sensor.

Technical specifications:

• EMC-free 2-conductor cable attached to a fiberglass mesh
• 2.5-meter three-core power cable
• Complete enclosure with aluminum earth sheath
• Unique concealed connection between heating and supply cable
• Chrome/nickel resistance wire
• PTFE (Teflon) insulation
• PVC protective sheath
• 10-11 watts per meter resistance wire, 230 volts
• Cable diameter approximately 4 mm
• Mat width of 25 or 50 cm
• Complies with current NEN standards for installation in entire wet areas
• 0.75 m² - 10.0 m²: 150 watts per m² / 12.0 m² - 25.0 m²: 125 watts per m²

Installation methods:

• Directly in tile adhesive
• Self-leveling screeds
• In plaster/mortar
• Anhydrite floors